c48f42e178
Using HALT to immediately jump to the end of the shader is required to implement GL_EXT_gpu_shader4 and OpenGL 3.0. However, vanilla OpenGL 1.2 doesn't forbid it and it likely makes something somewhere faster. We should be consistent and implement the same discard behavior on all hardware if we can. The rules for HALT on Gen4-5 are a bit different from Gen6+. On the older hardware, there is no stack for HALT; instead it's up to software to save and restore mask registers. However, there's no real saving needed since we only use HALT to jump to the end of the program where we're about about to do our FB writes. All we need to do is reset AMask to DMask, the value it was initialized to at the start of the thread. Reviewed-by: Kenneth Graunke <kenneth@whitecape.org> Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/5244>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.html <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.html <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `Freenode's #dri-devel <irc://chat.freenode.net#dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.html <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.html <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.