a8ec4082a4
This introduces new vec8 and vec16 instructions (which are the only instructions taking more than 4 sources), in order to construct 8 and 16 component vectors. In order to avoid fixing up the non-autogenerated nir_build_alu() sites and making them pass 16 src args for the benefit of the two instructions that take more than 4 srcs (ie vec8 and vec16), nir_build_alu() is has nir_build_alu_tail() split out and re-used by nir_build_alu2() (which is used for the > 4 src args case). v2 (Karol Herbst): use nir_build_alu2 for vec8 and vec16 use python's array multiplication syntax add nir_op_vec helper simplify nir_vec nir_build_alu_tail -> nir_builder_alu_instr_finish_and_insert use nir_build_alu for opcodes with <= 4 sources v3 (Karol Herbst): fix nir_serialize v4 (Dave Airlie): fix serialization of glsl_type handle vec8/16 in lowering of bools v5 (Karol Herbst): fix load store vectorizer Signed-off-by: Karol Herbst <kherbst@redhat.com> Reviewed-by: Dave Airlie <airlied@redhat.com>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.html <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.html <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `Freenode's #dri-devel <irc://chat.freenode.net#dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.html <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.html <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.