00ad29dd23
New tests, dEQP line rasterization test fix that lets Intel pass. Clears out bogus xfails from 1.3.2.0 uprev on a630, which I suspect were "we lost the device twice on a full run once, and those fails got pasted in without checking if it happened a full run again" (since we haven't seen them in other full run attempts). Also clears out the a630 vk asan xfails (essentially all tests run) by turning off leak detection which was just catching leaks in vkcts. Acked-by: Jason Ekstrand <jason@jlekstrand.net> Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/17304>
`Mesa <https://mesa3d.org>`_ - The 3D Graphics Library ====================================================== Source ------ This repository lives at https://gitlab.freedesktop.org/mesa/mesa. Other repositories are likely forks, and code found there is not supported. Build & install --------------- You can find more information in our documentation (`docs/install.rst <https://mesa3d.org/install.html>`_), but the recommended way is to use Meson (`docs/meson.rst <https://mesa3d.org/meson.html>`_): .. code-block:: sh $ mkdir build $ cd build $ meson .. $ sudo ninja install Support ------- Many Mesa devs hang on IRC; if you're not sure which channel is appropriate, you should ask your question on `OFTC's #dri-devel <irc://irc.oftc.net/dri-devel>`_, someone will redirect you if necessary. Remember that not everyone is in the same timezone as you, so it might take a while before someone qualified sees your question. To figure out who you're talking to, or which nick to ping for your question, check out `Who's Who on IRC <https://dri.freedesktop.org/wiki/WhosWho/>`_. The next best option is to ask your question in an email to the mailing lists: `mesa-dev\@lists.freedesktop.org <https://lists.freedesktop.org/mailman/listinfo/mesa-dev>`_ Bug reports ----------- If you think something isn't working properly, please file a bug report (`docs/bugs.rst <https://mesa3d.org/bugs.html>`_). Contributing ------------ Contributions are welcome, and step-by-step instructions can be found in our documentation (`docs/submittingpatches.rst <https://mesa3d.org/submittingpatches.html>`_). Note that Mesa uses gitlab for patches submission, review and discussions.